Results 1 to 9 of 9

Thread: BEP920 - Steam wand 3 beeps

  1. #1
    Junior Member
    Join Date
    Aug 2017
    Posts
    3

    BEP920 - Steam wand 3 beeps

    Hello all,

    I just purchased a brand new BEP920 and I have followed the setup instructions correctly (i believe).

    I power the machine on and wait until it reaches 93 degrees.
    I've flushed the group head hot water outlet, but every time I move the Steam wand into the up position, all I hear are 3 beeps and no steam.

    Any ideas?

  2. #2
    Senior Member
    Join Date
    Jul 2012
    Posts
    118
    Steam boiler is not up to temperature. That's what the beeps are saying.

  3. #3
    Junior Member
    Join Date
    Aug 2017
    Posts
    3
    Quote Originally Posted by Chris View Post
    Steam boiler is not up to temperature. That's what the beeps are saying.
    Thanks for your quick reply Chris!

    Oh ok, I thought once the machine hits its temp of 93 degrees Celsius and the 1 cup - 2 cup LEDs turn on that it's ready.

    I'll turn it on and leave it for a while tomorrow before trying again.

  4. #4
    Senior Member
    Join Date
    Jul 2012
    Posts
    614
    Your hot water tap just needs to be turned off. To make sure its off, turn it all the way on so that got water is coming out then turn the dial completely off. Then try your steam again....

  5. #5
    Senior Member
    Join Date
    Jul 2012
    Posts
    118
    Quote Originally Posted by dtcobra View Post
    Thanks for your quick reply Chris!

    Oh ok, I thought once the machine hits its temp of 93 degrees Celsius and the 1 cup - 2 cup LEDs turn on that it's ready.

    I'll turn it on and leave it for a while tomorrow before trying again.
    Thats for your brew boiler. The steam boiler can lag behind a little especially if recent fully filled with cold water. Normally you won't notice. As Melb says check the hotwater tap is closed also.

  6. #6
    Senior Member level3ninja's Avatar
    Join Date
    Nov 2013
    Location
    Casula, NSW
    Posts
    534
    It normally takes about 2 minutes longer for my steam to reach temperature after the brew boiler.

  7. #7
    Junior Member
    Join Date
    Aug 2017
    Posts
    3
    Quote Originally Posted by level3ninja View Post
    It normally takes about 2 minutes longer for my steam to reach temperature after the brew boiler.
    Bingo! That's all it was. I was impatient I had a laugh. Everything works well. Thanks everyone.

  8. #8
    Junior Member
    Join Date
    May 2011
    Posts
    1
    Similar issue, mine just needed display reset (pg 29) and worked fine. Air bubble trapped possibly.

  9. #9
    Junior Member
    Join Date
    Oct 2017
    Posts
    1
    Hi All
    First time poster. I just purchased the Breville Dynamic Duo setup after lots of research on this forum. Big thanks to everybody that posts their experience and opinions.
    I had the same issue with my steam wand during setup and had to do a "reset to default settings" as adonit describes above. Worked fine after that.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •