Announcement

Collapse
No announcement yet.

sunbeam 6910 only power light flashing

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • pwinch
    replied
    Thanks Tampit. Tried to do a reset but now the only button functioning is the power button.

    In another post it was suggested by noidle22 that a thermal fuse EM69163 may be the issue?

    I guess it could also be the control board circuit board?

    Leave a comment:


  • TampIt
    replied
    Do a factory reset (manual somewhere on this site).

    If that fails, noidle22 is your friend...

    Leave a comment:


  • pwinch
    started a topic sunbeam 6910 only power light flashing

    sunbeam 6910 only power light flashing

    My machine has been working well until I used the hot water to warm a cup, pulled a shot and then began to use the steam wand. It continued to pump out water a bit like the hot water outlet and did the same after a few tries. All lights were lit on the control panel.I thought I would turn the power off using the control panel button and restart to try to fix it.
    When I turned the machine back on using the power button, it flashed as usual, but no other lights came on. Tried again several times with the same result.
    I removed the top panel to have a look, but all seems free from water damage.
    Any ideas where to go from here?
Working...
X