If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
Minimum pipe size for plumb in rotary pump machine
Re: Minimum pipe size for plumb in rotary pump machine
Thanks BF
just going to run the drain across the bench to sink right now... its close. The DWasher is nearby so might jump onto that drain line underbench
if 6mm is all then i might just run some copper up under the bench and around the lip U shaped and drape a steam wand cloth over it
i have some copper spare
i was just looking inside the machine and thinking there is a lot of 6mm ish pipe running feed lines inside
machine is sitting in the middle right now bu i am already sick of it being in the way of the prep space
Re: Minimum pipe size for plumb in rotary pump machine
Bit of lateral thinking what about wall mounted outlet on the splashback area (Marine bulkhead fitting below). Very low flow rates needed into the machine so 6mm OD Nylon is fine (I think 4mm ID) but bigger is ok too.
Are you going to run the drain straight to the sink or block the drip tray off and empty it manually?
Minimum pipe size for plumb in rotary pump machine
What would be the minimum pipe size for plumb in rotary?
Its for the Brugnetti 5L boiler HX roto-flow commercial machine i have
pump is external, it will more than likely end up under the sink and a copper line run to the machine
whats the min i could go on the pump to machine
water tap to pump can be 15mm no problem undersink
I have moved into the "new" house and am fitting in the machine, issue is i have stone benches in kitchen and reluctant at this stage to drill a hole.....
considering a plug an play for a bit till i sort out a "hole" and looking at john guest water filter / beer line set up or 1/4 inch copper etc.
might sneak through the wall around the benchtop.....
Leave a comment: