Hi,
Newbie here, first time post. Hi everyone, & please be gentle.. :-)
I have a Rancilio Epoca S1-Tank, which I've had for 8 years or so and for the last year it sat in the garage. I recently decided to get it going again.
I was amidst a backflush when things went a bit awry. When I press the button, the motor runs, however nothing from the group.
Here's what I've done so far:
- Replaced 3-way Solenoid
- Replaced Pump
- Replaced shower screen & group gasket
... All to no avail.
The pressure gauge shows correct pressure, which I hope means the boiler is OK. Also the Steam & Hot Water are working fine.
I can't see any water leakage (or steam).
Is it possible that the limescale could be *so* built up as to block the flow out to the group head?
Any and all assistance is *greatly* appreciated.
Thanks,
Jason
Newbie here, first time post. Hi everyone, & please be gentle.. :-)
I have a Rancilio Epoca S1-Tank, which I've had for 8 years or so and for the last year it sat in the garage. I recently decided to get it going again.
I was amidst a backflush when things went a bit awry. When I press the button, the motor runs, however nothing from the group.
Here's what I've done so far:
- Replaced 3-way Solenoid
- Replaced Pump
- Replaced shower screen & group gasket
... All to no avail.
The pressure gauge shows correct pressure, which I hope means the boiler is OK. Also the Steam & Hot Water are working fine.
I can't see any water leakage (or steam).
Is it possible that the limescale could be *so* built up as to block the flow out to the group head?
Any and all assistance is *greatly* appreciated.
Thanks,
Jason

Comment