Hello,
I took the main screw (part called Flange) that holds the cam shaft (axis brew group part 5) off to give a little grease to smooth it up and ive noticed the brew lever is getting very tight to turn. So tight is it, that it simply spin the main screw rather than the cam shaft rotating within the main screw. I've checked the diagram of the part and it doesnt appear as if anything could be causing it to become and issue. Looking down the flange body as its assembled and everything is straight, there doesnt appear to be a tight gap and i assume from the spring (Part 7) within the flange group that would allow part 36 to freely move to centre itself with the axis group (part 5)
It is starting to become so tight that rather than the cam shaft turning within the main screw, it will twist the screw undone.

Any ideas?
I took the main screw (part called Flange) that holds the cam shaft (axis brew group part 5) off to give a little grease to smooth it up and ive noticed the brew lever is getting very tight to turn. So tight is it, that it simply spin the main screw rather than the cam shaft rotating within the main screw. I've checked the diagram of the part and it doesnt appear as if anything could be causing it to become and issue. Looking down the flange body as its assembled and everything is straight, there doesnt appear to be a tight gap and i assume from the spring (Part 7) within the flange group that would allow part 36 to freely move to centre itself with the axis group (part 5)
It is starting to become so tight that rather than the cam shaft turning within the main screw, it will twist the screw undone.
Any ideas?

Comment