Only then, you would be able to turn the machine ON and press the STOP/START (20) button to enter programming mode, hearing a beep.
The machine would then be ready for the programming by holding the various dispensing buttons.
The manual however talks about three modes: not abled programming, abled programming and computer interface mode.
It also is unclear whether the white area is the switch or the black area is supposed to be the switch.
I tried all six possible combinations, and every combination causes the machine to dispense water from both groups and the hot water at start-up.
Except when you put the machine in ON OFF OFF OFF for abled mode and OFF ON OFF OFF for computer interface.
Both don't allow me to hear a beep after pressing the START/STOP button.
Computer interface (engineering?) mode, did reset all of my buttons, and most of them aren't working anymore.
Does anyone have any experience with this process?
