If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Originally posted by 5054726B6B6E716669070 link=1260969065/9#9 date=1261058917
if that, these guys are lightening fast!
Too right.... ;D
I ordered a few bits and pieces a couple of days ago and the order arrived before my payment would have even cleared .... I think there is something very special about the CoffeeParts guys 8-)
Hey tashie,
I found a good trick when screwing on the new one, if it doesnt tighten in the right place (at teh angle you want) use plumbers tape to force it to tighten earlier, bit of test and adjust but it works good, i bought a open double from coffee parts and i wanted it to sit hanging off the front of the group handle so i could see the flow better, this trick worked great!
Silvia group handle thread is 3/8" BSP a commercial spout like coffeeparts 511672 will be fine just remove the cover piece over the spouts to show more of the pour.
I so cant afford a Naked PF But daymn theyre cool.
I meant the PF spout but where the top bit is open so that I can see the whole pour - not sure if that makes sense. I know Pullman sell the spout on their site but its for a Sunbeam.
Leave a comment: