Originally posted by 56717B7329212F2B180 link=1289558982/4#4 date=1289562608
As stated above... If your sure it is the machine...
Then steam pump would be my first guess, if all was OK previously.
Un aware of any others that are Authorised in Brisbane. Know that at least one or two others that do attempt / offer services... But would not even consider taking any thing to them; unless I want to be ripped off.
Steam is and can be a right PAIN... EM6910 has TWO extras working for it over the EM6900
1: You can change TEMP and Flow rate and easy to access....
Thus I would reset to default settings and then make one change at a time...
A: First would be Steam Heat and up to the max..
B: Then I would look at the WETTEST and the DRIEST settings.
Test from Cold and post warm up at each setting and double check each time...
I would not take it anywhere for a repair / Quote until fully tested and you can clearly prove the fault... Many repairers would just side pass the issue unless it is very clear that it is not working...
I am assisting with an EM6900 at the moment and a right pain... HARD to get access to and no adjustments as to settings... Thus any change in pump specs and or dirty Steam thermoblock and it makes it hard to even guess or prove without a full dismantle.. PITA big time...


Leave a comment: