Hey all,
A long time between posts, I couldn't for the life of me remember my old username or log in for this forum so created a new one.
I am just chasing some assistance in repairing a Lucy machine. Had a boiler seal blow 12months ago, so was taken off bench for repairs/refresh. Life happened and I kind of forgot about the old girl, anyway.
New seals throughout now but on putting it all back together I now have no heat!
Replaced the resettable thermostat earlier today, no heat. Cracked out the multimeter and this is where I need some experienced advice.
With the multimeter set to 200k, I get a reading of 00.1 on the element, the brew and steam thermostat and the resttable???? What the?
Is this not the right Ohms setting to use?
When I put it into storage, everything was fine excluding the leaking boiler seal which was a slow drip.
Pump is still working, grinder is still working just no heat.
Any assistance would be appreciated.
Cheers
A long time between posts, I couldn't for the life of me remember my old username or log in for this forum so created a new one.
I am just chasing some assistance in repairing a Lucy machine. Had a boiler seal blow 12months ago, so was taken off bench for repairs/refresh. Life happened and I kind of forgot about the old girl, anyway.
New seals throughout now but on putting it all back together I now have no heat!
Replaced the resettable thermostat earlier today, no heat. Cracked out the multimeter and this is where I need some experienced advice.
With the multimeter set to 200k, I get a reading of 00.1 on the element, the brew and steam thermostat and the resttable???? What the?
Is this not the right Ohms setting to use?
When I put it into storage, everything was fine excluding the leaking boiler seal which was a slow drip.
Pump is still working, grinder is still working just no heat.
Any assistance would be appreciated.
Cheers

Comment