Hi,
I've just picked up a non-functioning Paros and hoping to get it working again without spending a fortune, but need some advice..
The machine turns on and the pump works, however the boiler doesn't warm up. I'm assuming that the heating elements are the two u-shaped attachments either side of the boiler, with the electrodes at the top. One of the elements creates a circuit when I attach a multimeter to the electrodes but nothing from the other element, so I'm assuming this is my culprit and I need to pick up a new boiler?
Also I'm a little concerned by the signs of heat / blackening of the connectors on the red wires that connect to the boiler (top right and bottom left) - is that normal?

Thanks!
I've just picked up a non-functioning Paros and hoping to get it working again without spending a fortune, but need some advice..
The machine turns on and the pump works, however the boiler doesn't warm up. I'm assuming that the heating elements are the two u-shaped attachments either side of the boiler, with the electrodes at the top. One of the elements creates a circuit when I attach a multimeter to the electrodes but nothing from the other element, so I'm assuming this is my culprit and I need to pick up a new boiler?
Also I'm a little concerned by the signs of heat / blackening of the connectors on the red wires that connect to the boiler (top right and bottom left) - is that normal?
Thanks!

Comment