BH
For your info, and everyone else I guess, as we found this interesting...
One of the co-owners of the Scace 2 just dropped by to pick it up so we did a quick temp curve test to see if the good old $35 Digitech DMM is showing something close or whether we had to build in an offset for calibration...
Boiled the kettle and poured the just boiled water over the probe - reading 99.9 to 100.2 degrees, settling at 99.9
Put ice in a small jug, added a small amount of water so it would just melt and did same - reading 2.2 degrees.
Gotta love those metallurgical types

So get a DMM with temp and spade connector adaptor and try it out.
Otherwise, the cheapest I saw a T-type temp reader was $190.
Personally, I dont think Ill buy one ;D
Hope this helps
Chris


Leave a comment: