If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yeah, the CP ones are Ok but if as the OP does, you use it a lot, your fingers will definitely smell like stinky rubber in a fairly short time...
+1 for the Silicone Rubber Tubing.
I expect if you can easily remove the "head" of the water wand you could get a piece of silicone hose from an auto parts store that would slip over the wand. Most silicone hoses have a fairly high heat rating, won't smell like rubber and would be food safe.
I make quite a few long blacks and so the hot water wand gets a work out. But with how close it is to the brew lever there are a few burned knuckles along the way. I printed a simple clip from ABS but the heat makes it too pliable and it keeps popping off.
Is there anything else available that can clip over it for easy manipulation/manoeuvring?
Leave a comment: