Hey all,
Just bought a flow control device from a forum member, and after installing the pressure gauge needle keeps getting stuck.
So first shot is ok, it rises and falls normally, then second shot it will become sticky/grainy in its movement instead of smooth, then third shot it will just be stuck at a point on the dial (say, 3 bar) and not move during the shot or even once I put the lever all the way down to stop the shot.
If it take the gauge out, and give it a shake, it will go back to normal, but that made condensation get in the gauge. Then I reinstall and the same thing happens: first shot ok, second shot sticky, third shot stuck.
can anyone help me fix this?
Just bought a flow control device from a forum member, and after installing the pressure gauge needle keeps getting stuck.
So first shot is ok, it rises and falls normally, then second shot it will become sticky/grainy in its movement instead of smooth, then third shot it will just be stuck at a point on the dial (say, 3 bar) and not move during the shot or even once I put the lever all the way down to stop the shot.
If it take the gauge out, and give it a shake, it will go back to normal, but that made condensation get in the gauge. Then I reinstall and the same thing happens: first shot ok, second shot sticky, third shot stuck.
can anyone help me fix this?

Comment