Hi csers
So I recently got my machine serviced and descaled and they've decided to put the boiler pressure up to 1.2 from 1
I recently got a group head temperature gauge as well and I'm seeing temps just over 100 and needing to flush a mug of water before dropping down to 92-94. About 20 or 30 secs after heating up for 40 mins.
I've got a Mater pressure stat so I turned it 45 degrees anticlockwise to reduce it. Got it to 1.1. Temps are better but still needs a decent flush. So I did the same again and the boiler pressure went nuts. Up to 1.25 and then to 1.4 after pulling a shot.
Do I need to give it some time to adjust or should it show boiler pressure changes immediately?
So I recently got my machine serviced and descaled and they've decided to put the boiler pressure up to 1.2 from 1
I recently got a group head temperature gauge as well and I'm seeing temps just over 100 and needing to flush a mug of water before dropping down to 92-94. About 20 or 30 secs after heating up for 40 mins.
I've got a Mater pressure stat so I turned it 45 degrees anticlockwise to reduce it. Got it to 1.1. Temps are better but still needs a decent flush. So I did the same again and the boiler pressure went nuts. Up to 1.25 and then to 1.4 after pulling a shot.
Do I need to give it some time to adjust or should it show boiler pressure changes immediately?

Comment