Hi All,
Couldn't remember my old username/email I used to join so here I am under a new name! My trusty "old" (may 2000) model Office Control recently started playing up (light flashine while pulling shots) indicating reduced flow. so I gave it a de-scale & a good flush. Long story, next morning the machine didn't automatically stop the shot resulting in an extended pull which I stopped manually. Tried re=programming the 2 shot long which resulted in that button no longer working. Later that morning, turned it on to make another round & it no longer heats up. Upon closer inspection, I removed the level sensor wire & nothing, so I'm thinking the board is buggered & possibly the Heating element (tested 47 Ohms across the terminals) too? I called Di Save in Melb & was advised it's the Pressurestat (sounds very unlikely to me but I'm not a Tech).
What are your thoughts Guys? Any Ideas?
Micko
Couldn't remember my old username/email I used to join so here I am under a new name! My trusty "old" (may 2000) model Office Control recently started playing up (light flashine while pulling shots) indicating reduced flow. so I gave it a de-scale & a good flush. Long story, next morning the machine didn't automatically stop the shot resulting in an extended pull which I stopped manually. Tried re=programming the 2 shot long which resulted in that button no longer working. Later that morning, turned it on to make another round & it no longer heats up. Upon closer inspection, I removed the level sensor wire & nothing, so I'm thinking the board is buggered & possibly the Heating element (tested 47 Ohms across the terminals) too? I called Di Save in Melb & was advised it's the Pressurestat (sounds very unlikely to me but I'm not a Tech).
What are your thoughts Guys? Any Ideas?
Micko

Comment