Hi all,
I have a Euro 2000 machine bought new in 2005, a couple of years ago the GICAR level controller failed and was replaced with a GIEMME RLO controller. I never wired it in as life got in the way. Jump forward 3 years and I have resurrected the machine, dismantled and cleaned all components, reassembled. Using a diagram online I have wired the controller in and have had some success, it heated, made steam and hot water ran through the brew group. However the next day when turned on the machine trips the house earth leakage breaker. If I remove the overpressure sensor wire the circuit breaker does not trip and the pump will run. I am out of ideas and ready to send it to town for a service. level 4 lockdown in Auckland prevents this at the moment. If anyone has any advice I would be grateful.
I have a Euro 2000 machine bought new in 2005, a couple of years ago the GICAR level controller failed and was replaced with a GIEMME RLO controller. I never wired it in as life got in the way. Jump forward 3 years and I have resurrected the machine, dismantled and cleaned all components, reassembled. Using a diagram online I have wired the controller in and have had some success, it heated, made steam and hot water ran through the brew group. However the next day when turned on the machine trips the house earth leakage breaker. If I remove the overpressure sensor wire the circuit breaker does not trip and the pump will run. I am out of ideas and ready to send it to town for a service. level 4 lockdown in Auckland prevents this at the moment. If anyone has any advice I would be grateful.
