If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Originally posted by 7A726A607D190 link=1292415372/16#16 date=1292650389
Originally posted by 4A475252437944495F260 link=1292415372/15#15 date=1292647708
yep
how much do think it would cost to take it to a machine shop?
Just petrol, dependent on how far it is
;D
Cruel but literal
Look a few ways to repair and it depends on teh Shop/ factory and the staff. Old school and old style trades person would have a few options...
The L/H stud will be teh biggest issue. Go and do some searching of the Nut and Bold suppliers in you area. If you can get a suitable Stud / Bold that suits in size and thread. Then a good tradie would be able to mod the the stud with out too much trouble and machine and fit to teh shaft.
Depending on teh tradie and how they feel... A couple of $$$ up to say $185 plus at standard Hrly rates.
See a motor rewinder if you have any locally... They may be able to do if you have teh stud etc..
Comment