Just replaced parts. Noticed that the fit seems more interference than kiss, when the conical burr assembly seats in the blade outer assembly. Quite tight to push in.
I cannot see it rise and fall with click adjustment, which I can see with the old blades.
Even though Ive taken great care to make sure protrusions line up with their seats.
One surprise, though it shouldnt have been, was the left-hand thread on the burr securing nut. TG I thought of it.
Any thoughts on this? Just seems like the tolerances on the hard plastic housing of the new part are not fine enough for it to fit the outer on the machine. :-/
About to put old parts back in. Not happy, Jan.
I cannot see it rise and fall with click adjustment, which I can see with the old blades.
Even though Ive taken great care to make sure protrusions line up with their seats.
One surprise, though it shouldnt have been, was the left-hand thread on the burr securing nut. TG I thought of it.
Any thoughts on this? Just seems like the tolerances on the hard plastic housing of the new part are not fine enough for it to fit the outer on the machine. :-/
About to put old parts back in. Not happy, Jan.

Comment