Hi all,
so Ive had 2 "real" grinders now - a GR RR45 and a K3T and they both suffer (to different extents) the same problem: some beans (or broken bits) get stuck under the lower burr on the inside of the chamber. The GR was worse with a large amount of grinds getting stuck there too.
I thought of using some food-grade filler (silicone or something?) and putting a smooth edge on it to stop this, but it would have to be something fairly tough so it didnt chip off into the blades, but that I could remove eventually when I replace them.
Any ideas / thoughts?
thanks
so Ive had 2 "real" grinders now - a GR RR45 and a K3T and they both suffer (to different extents) the same problem: some beans (or broken bits) get stuck under the lower burr on the inside of the chamber. The GR was worse with a large amount of grinds getting stuck there too.
I thought of using some food-grade filler (silicone or something?) and putting a smooth edge on it to stop this, but it would have to be something fairly tough so it didnt chip off into the blades, but that I could remove eventually when I replace them.
Any ideas / thoughts?
thanks

Comment