Announcement

Collapse
No announcement yet.

K3 Problems

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • K3 Problems

    Ive pulled the burrs off, cleaned, and replaced. It seems to be working a little better. However...

    1) Theres still a fair amount of noise (squeaking etc.) that sounds like its out of balance.

    2) It also stopped grinding again (though the burrs were moving) when I was adjusting the burr carrier to a finer level. This seems to have rectified itself, but is a bit worrying.

    3) I also noticed that the washer under the brass centre nut was off centre. Is it supposed to be this way to throw the beans out or is it supposed to be centred? Im suspecting that this may be a cause of the problems?

    Any advice would be appreciated.

    Cheers,

    Kit

  • #2
    Re: K3 Problems

    I hope my PMed advice helped

    Comment


    • #3
      Re: K3 Problems

      Originally posted by 66787A7E706C7170767E150 link=1272928046/0#0 date=1272928046
      3)I also noticed that the washer under the brass centre nut was off centre.Is it supposed to be this way to throw the beans out or is it supposed to be centred?Im suspecting that this may be a cause of the problems?
      My washer is the same of centre no worries though ....

      Gra..

      Comment


      • #4
        Re: K3 Problems

        Thanks guys.

        A good cleaning and making sure I dont try to grind nano-particles seems to have done the trick.

        Comment

        Working...
        X