If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
What spares do you need? If you're looking for Burrs you can get them from coffeeparts.com.au (site sponsor).
Other than that try pinging the sponsors email (or use the quote form at the top of the page) to contact all sponsors, if they can't help they'll be able to point you in the right direction.
Cheers for the reply, I have contacted a sponsor to see what they can advise.
I just need the hopper protector, 4 screws and the hopper gate. The burs seem in pretty good condition, the bur screws have been removed and put in wrong :S so I know its had some new Burs since new. Going to run a couple of Kilos through before I get a new set of Burs.
well, if you cant find originals, those items you list are probably the most likely bits of your grinder that you will be able to fabricate / substitute on the entire machine.
the hopper protector *could be fashioned up with a dirty magnet in the middle and the hopper gate is a stainless piece, almost sheet metal thin.
64mm burrs from CoffeeParts are $64 delivered.
I'm about to post a question about the MD50 - so get in touch if you have any recommendations.
Comment