If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
On the junior it is normal thread, see if you can see the angle of the thread at the very top before the shaft starts (hard to tell in pic if a bit is visible).
I inserted a rod into the throat of the grinder and locked the shaft inplace by bracing one of the tabs on the bottom burr carrier, loaded up the nut and gave the ratchet a sharp tap and it cracked loose with little effort.
Leave a comment: