If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yep - that's about right. On my Lido 2, the burrs touch slightly past the zero marker, but close enough. Wind it up till they touch - then measure back from there
Cheers Matt
Hi,
on the above grinder, if I am understanding this right, does zero setting mean the first contact the burrs make when screwing in the adjusting ring?
I think it does, just need confirmation.
Leave a comment: