Hello, some help with my mazzer sj would be nice. I would like to remove the auto stop switch "plastic stop flap" above the exit from the burrs.
It is nice to "see" the grinds coming out to make quick adjustments easier if grinds clump, or look too fine etc. Also it would make cleaning up the chamber far easier; and it is not like I use the damn thing! Grind on demand works best for me.
Dosing chamber comes off easily, so does the plastic stop unit as well; however disconnecting the wires... Read on.
I notice a lot of wires in the sj, if I remove the two (light grey) wires from the white plastic loom panel, do I have to join the circuit back up with some of the removed wire? Yes, no? Also there is another length of wire that runs (in a yellow conduit) into the bottom of the dosing chamber; is this part of the auto stop switch too?
If anyone has done this mild mod; please assist. Many thanks.
Also I am looking for a grinds tray for under the feet of the grinder for the mess I make. If anyone knows where I can buy one; would be very nice.
Scott.
It is nice to "see" the grinds coming out to make quick adjustments easier if grinds clump, or look too fine etc. Also it would make cleaning up the chamber far easier; and it is not like I use the damn thing! Grind on demand works best for me.
Dosing chamber comes off easily, so does the plastic stop unit as well; however disconnecting the wires... Read on.
I notice a lot of wires in the sj, if I remove the two (light grey) wires from the white plastic loom panel, do I have to join the circuit back up with some of the removed wire? Yes, no? Also there is another length of wire that runs (in a yellow conduit) into the bottom of the dosing chamber; is this part of the auto stop switch too?
If anyone has done this mild mod; please assist. Many thanks.
Also I am looking for a grinds tray for under the feet of the grinder for the mess I make. If anyone knows where I can buy one; would be very nice.
Scott.

Comment