Announcement

Collapse
No announcement yet.

Macap M2M Chute removal?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • yldlj
    commented on 's reply
    Thanks, next time I give it a clean I will look for this.

  • wirecutter23
    replied
    There is another bolt that can be accessed by taking the base off the bottom of the grinder. Make sure to do this with the grinder unplugged as there are exposed electronics in there. Good to give it a clean out too as I often found a small amount of grounds make it into there over time.

    Leave a comment:


  • Caffeinator
    replied
    No need to. Bottle brush or remove the lower burr should you feel so inclined- and then brush out.

    Leave a comment:


  • dimmy
    replied
    I don't know how to remove the chute, but would this help? https://www.espressotec.com/macap-m2-parts-diagram.html

    Leave a comment:


  • yldlj
    started a topic Macap M2M Chute removal?

    Macap M2M Chute removal?

    Anyone know how to remove the chute on the Macap M2M? I removed the top burr carrier and seen there is an Allen key at the top holding it in, but after removing this bolt I still couldn't take the chute off. Just want to give it a good clean, thanks.
Working...
X