Tweet
For those who cant justify $105 for a bottomless 6910 portafilter, Murphy may be your friend. One of these brand spankers came out of the lathe chuck when it was being converted and had a good old bounce on several metal surfaces on the way to the nice soft concrete floor! 
The machining is as perfect as all the others but due to this unplanned excursion there are a few marks on the rest of the unit. Most notably there is a scuff on the end corner of the handle (if cylinders have corners...) and a dent right at the other end of the chromed brass section (that would face the rear of the machine when installed). There may be other minor marks but these are the most obvious.
Yours for $79 plus postage, or pickup available from WA.
Greg
The ***very*** small amount of damage is highlighted within the rings! There is a small dent and a bit of scuffing at the end of the handle..... but it is minimal damage really....
A bargain for someone!!
Robin.
The machining is as perfect as all the others but due to this unplanned excursion there are a few marks on the rest of the unit. Most notably there is a scuff on the end corner of the handle (if cylinders have corners...) and a dent right at the other end of the chromed brass section (that would face the rear of the machine when installed). There may be other minor marks but these are the most obvious.Yours for $79 plus postage, or pickup available from WA.
Greg
The ***very*** small amount of damage is highlighted within the rings! There is a small dent and a bit of scuffing at the end of the handle..... but it is minimal damage really....
A bargain for someone!!
Robin.
Comment