Results 1 to 1 of 1

Thread: Nozzle Replace problem..

  1. #1
    Junior Member
    Join Date
    Nov 2012
    Posts
    20

    Nozzle Replace problem..

    Gene Cafe Coffee Roaster $850 - Free Beans Free Freight
    Hey all.. I have just replaced the nozzle on the steam wand of my EM7000 machine and now I cannot get good texture with it. The old one had a smaller hole and the newer (genuine) one is wider. My technique is to tilt the cup/mug to get the steam moving "across" the top of the milk, then I lower it under around 1/3 of the way along as it's heating up. It has always worked well to this point but perhaps my technique could be better.. Now I'm just getting milk with a lot of fine bubbles on top.

    Any ideas? Thanks.
    Last edited by IvanG; 1 Week Ago at 06:48 AM.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •